To make recording on the SD memory
1.Check the <Total Size> and the <Free Size>.
2.If the SD memory has a sufficient free space, set <Record> to On.
Otherwise, check the stored data and if you find them not important, then click <Format> to format the SD memory.
If your SD memory card writes slowly, only one frame per second will be stored.
For a SD memory card with a large capacity, the formatting will be slowed down accordingly.
Note that only one frame per second (1 fps) will be stored for the following resolutions : 1280x1024, 1280x720, 800x600.
If the size of data grows with time, only 1 fps can be stored even if you set the record quality to Full Frame.
3.Specify the record conditions.
y Record 1 fps forcibly : Only one frame per second will be recorded regardless of the existing record profile.
y Overwrite : If the SD memory is full, this will delete old data and store new data in replacement.
y
y
4.When done, click [Apply].
M SETUP SCREEN
Alarm Input
You can set the alarm input type, activation time, and operation mode.
1.From the Setup menu, select the
<Event ( 
)> tab.
2.Click <Alarm input>.
3.Specify an input device.
y Normal Open : It is normally open, but if it is closed, an alarm will be triggered.
y Normal Close : It is normally closed, but if it is open, an alarm will be triggered.
4.Specify the <Activation time>.
y Always : Always activates when an alarm occurs.
y Only scheduled time : Activates at a specified day of the week for a specified time period. The start time should be earlier than the end time, both of which are different with each other.
