Sharp TU-TV322H Remote Control, Inserting the batteries, Using your DTR Remote to control your TV

Remote Control

Inserting the batteries

Insert the batteries into the handset as shown. Point the remote control at the DTR and press the DTR button. The DTR button will flash once to confirm that the remote control is working correctly.

Important information regarding the batteries

Do not mix different types of batteries or new and old batteries. Do not use re-chargeable batteries. Do not throw batteries into a fire, do not recharge them. Remove the batteries from the remote control if you are not going to use it for several weeks. Immediately remove any leaking batteries. Take care in doing this, as leaking batteries may cause burns to the skin or other physical injury.

Please respect the environment and prevailing regulations. Before you dispose of batteries ask your dealer whether they are subject to special recycling and if they accept them back.

Using your DTR Remote to control your TV

The DTR remote control is capable of controlling the common functions of your TV. Locate the “Remote control TV set-up codes” sheet from your accessories and find your make of TV on the list. Note the four digit number(s) applicable to your TV. On the DTR remote Press TV, now press and hold OK and AV together. The TV button will flash twice. Now enter the 4 digit code relating to your make of TV. Again the TV button will flash twice. If an invalid code is entered, the TV button will only flash one long flash.

Make sure that the entered code is the right one for your TV by pressing the ‘active’ buttons from the list below. If your TV does not respond, repeat the sequence with the next available code in the table. Once you are sure that the code is correct you can write it down in the box to the right and on an identical label on the inside battery door of your DTR remote control.

Controlling your TV set

TV	Sets the remote control unit in TV mode (by pressing
	once) and enables you then to control your TV set.
	Switches the TV set on or off.
Vol. +/-	TV volume control.
	Switches sound off or on again.
CH +/-	Switches channel or selects an AV socket.
AV	Selects an AV socket.
0 to 9	Change channel or enters digital values.
TEXT	Access Teletext pages (On / Off).
‘Play’ button	Access Teletext pages (Off).
Colour buttons	Enables you to use the Teletext function on TV sets.

Information

37