Sharp UP-600, UP-700 instruction manual Select “INLINE SETTING” and press the ENTER key

Turn the mode switch to the PGM2 position.

2.Setting the terminal numbers (IRC machine numbers) — master and satellite

It is assumed that your terminal’s setting for inline operations has been performed.

1.

2. Select “INLINE SETTING” and press the [ENTER] key.

The INLINE SETTING menu will open.

3. Enter a terminal number for IP ADDRESS 4 from (0 - 254) and press the [ENTER] key.

4. Repeat steps 1 to 3 for all machines in the IRC system.

NOTE

•Terminal numbers must be assigned to the master and each satellite in the IRC system. (For setting the master’s terminal number, see the next paragraph.)

•If an inline network contains two or more machines with the same terminal number, IRC communications will not be achieved correctly. Each terminal number must be unique.

•The terminal number should be within the range from 1 to 254.

•If the terminal number “000” is programmed for a machine, it is put in the OFF LINE mode and cannot take part in IRC communications.

27