Sharp UP-600, UP-700 instruction manual The default setting is 0 no back-upmaster

5. Specifying the terminal to serve as a back-up master — master

You can assign one satellite to the function of a back-up master. If the master fails during guest check operation, the assigned terminal will perform the master’s function.

A machine number within the range from 1 to 999999 can be entered.

If zero is entered, there will be no back-up master in the IRC system.

This job can be done in the INLINE SETTING window of the master.

The default setting is 0 (no back-up master).

1. Turn the mode switch to the PGM2 position.

2. Select “INLINE SETTING” and press the [ENTER] key.

The INLINE SETTING menu will open.

Then, press the [CA/AT] key twice to appear “BMA

MACHINE” line.

3. Enter the machine number of the terminal to serve as a back-up master and press the [ENTER] key.

Important note:

To insure which satellite should be selected and to perform additional set up requirements, please consult your authorized SHARP dealer.

NOTE

The DECLARATION functions in the PGM2 mode enable the back-up master or the master to declare to be the master when the master or back-up master breaks down, and inform satellites of the master’s or back-up master’s recovery.

For details of these functions, see “Master declaration” and “Recovery declaration” on pages48 - 53.

31