Sharp UP-600 Direct Key Programming, Direct key, 128, Type Use the selective entry

Direct Key Programming

Use the following procedure to select direct-key programming:

■Direct key

You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to 3 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below. You can also select a key by directly pressing the corresponding direct key assigned on the keyboard.

Procedure	In the case of selecting “069 DIRECT PLU”
	• TYPE (Use the selective entry)
	PLU:	Assigns the key as a direct PLU key.
	DEPT:	Assigns the key as a direct department key.

NOTE

When selecting a department, the screen on which a department code is to be entered (the message “DEPT. CODE”) will appear.

▼

Select a pertinent key no. from the key numbers list, or directly press the key on the keyboard.

▼

▼

• LEVEL1 through 3 (Use the numeric entry)

Enter a PLU code for each level. For example, if you want to use this key as PLU code 1 (level 1) and PLU code 101 (level 2), enter 1 for “LEVEL1” and 101 for “LEVEL2.”

Key numbers

51	57	63	69
50	56	62	68
49	55	61	67
48	54	60	66
47	53	59	65

Departments and PLUs programmable area

NOTE

•You can assign departments and PLUs only the “Departments and PLUs programmable area” shown above.

•You cannot assign a department or a PLU to the position to which a function key has been assigned.

128