Sharp UP-820N Direct Key Programming, Direct key, 146, Assigns the key as a direct PLU key

Direct Key Programming

Use the following procedure to select direct-key programming:

■Direct key

You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to 10 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below.

Procedure

▼

Select a pertinent key no. from the key numbers list.

▼

▼

In the case of selecting “45 DIRECT DEPT”

• TYPE (Use the selective entry)

PLU:	Assigns the key as a direct PLU key.
DEPT:	Assigns the key as a direct department key.

NOTE

•You can also select a direct PLU key by pressing the corresponding key when the PLU has been assigned directly on the keyboard instead of selecting the key from the menu.

•When selecting a department, the screen on which a department code is to be entered (the message “DEPT. CODE”) will appear.

•LEVEL1 through 10 (Use the numeric entry)

Enter a PLU code for each level. For example, if you want to use this key as PLU code 1 (level 1) and PLU code 101 (level 2), enter 1 for “LEVEL1” and 101 for “LEVEL2.”

Key numbers

27 33 39 45 26 32 38 44 25 31 37 43 24 30 36 42 23 29 35 41

Departments and PLUs programmable area

NOTE

•You can assign departments and PLUs only for the “Departments and PLUs programmable area” shown above.

•You cannot assign a department or a PLU to the position to which a function key has been assigned.

146