Sharp UP-820N instruction manual Employee’s working time shift

■Employee’s working time shift

This function enables you to control the employees’ working time shifts. Working time shifts of a day are divided into a maximum of nine.

You can also use this function to control CCD entries, forcing the employees to make those entries at this operation (CCD per shift).

Example

In case you require the employees to make CCD entries at the working time shift operation and programmed the following working time shifts:

6:00 - 9:00	: MORNING01	(SHIFT1)	In this example, SHIFT7 to 9 are not used.
9:00 - 11:00	: MORNING02	(SHIFT2)	Press the ;key to move the current shift to
11:00 - 14:00	: LUNCH	(SHIFT3)	the next one.
14:00 - 16:00	: AFTERNOON	(SHIFT4)	When the shift reaches the last one (SHIFT6 in
16:00 - 19:00	: EVENING	(SHIFT5)	this example), it returns to the SHIFT1.
19:00 - 23:00	: NIGHT	(SHIFT6)
	Key operation		Display
		;
	Make the CCD entry.

▼

c

Select “1 YES”.

NOTE • To use this function, the employee must assign their working time shift at the time-in operation.

•The employee can make operations only at the assigned working time shift.

•If you program the POS terminal to require a CCD entry at the working time shift operation, the CCD entry window is displayed as shown above.

•You can also program the POS terminal to allow the employee to make a CCD entry anytime after the working time shift operation. In this case, the message “CCD IS NOT DONE” appears to remind you to complete the CCD entry if the employee makes a time-out operation without completing the CCD entry when the woking time is shifted.

99