Sharp UX-355L operation manual 136

Messages and Signals

LINE ERROR	Transmission or reception was not successful. Press
	the STOP key to clear the message and then try
	again. If the error persists, see Line Error on page
	130.
LINE IS IN USE	An extension phone connected to the fax is being
	used. Do not lift the fax's handset or attempt
	transmission at this time, as this will interrupt the
	conversation on the extension phone.
MEMORY IS FULL	The memory is full. This may occur during fax
	reception if too much data is received before the
	pages can be printed out. If faxes have been received
	to memory because printing is not possible (an
	additional message will indicate the problem), resolve
	the problem so that printing can continue (see
	Substitute Reception to Memory on page 80). If you
	are attempting to transmit from memory, see If the
	memory becomes full on page 111.
MEMORY PRINTING	The fax is preparing to or printing out a document
	from memory.
NO DATA	This appears if you attempt to search for an
	automatic dialing number when none have been
	stored.
NO SERVICE	This appears if you haven’t registered with OpenLCR
	and press the FUNCTION key and 7.
NO # STORED	You have tried to dial or clear a Rapid Key or Speed
	Dial number that hasn’t been programmed (a full
	number hasn’t been assigned to it).
OFF HOOK	This appears if you forgot to replace the handset after
	using it to dial and send a fax. Replace the handset or
	press the STOP key to clear the message.
ON HOOK DIAL	The SPEAKER key has been pressed and the fax
	machine is waiting for you to dial.
OUT OF PAPER	You are out of printing paper (or the paper release
	plate is open). Load paper as explained in Loading
	Printing Paper on page 22.

136