Regarding the Lamp5 Insert the new lamp unit.

•Press the lamp unit firmly into the lamp unit compartment. Fasten the securing screws.

6 Replace the lamp unit cover.

•Align the lamp unit cover and slide it to close. Then tighten the user service screw to secure the lamp unit cover.

Info

•If the lamp unit and lamp unit cover are not correctly installed, the power will not turn on, even if the power cord is connected to the projector.

User service screw (for lamp unit cover)

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.

Info

 

• Make sure to reset the lamp timer only

AC socket

when replacing the lamp. If you reset the

 

lamp timer and continue to use the same

 

lamp, this may cause the lamp to become

 

damaged or explode.

 

•You can also reset the lamp timer via the

LAN.

(Refer to the SETUP MANUAL on the supplied CD-ROM for details.)

1 Connect the power cord.

• Plug the power cord into the AC socket of the projector.

2 Reset the lamp timer.

• While simultaneously holding down ",

ENTER and MENU on the projector, press STANDBY/ON on the projector.

•“LAMP 0000H” is displayed, indicating that the lamp timer is reset.

STANDBY/ON button

ENTER button"button MENU button

-62