Troubleshooting (Continued)
Problem |
| Check | Page |
|
|
|
|
Picture is green on | • | Change the input signal type setting. | 46 |
INPUT 1 (COMPONENT)/ | • | When you cannot select an input signal type, select “Color is faded | 39, 46 |
INPUT 2 (COMPONENT). |
| or poor” in the “Help” menu, after selecting an item other than |
|
|
| “sRGB” in “Picture Mode”, and then select an input signal type. |
|
Picture is pink (no green) |
|
| |
|
|
| |
on INPUT 1 (RGB)/INPUT |
|
|
|
2 (RGB). |
|
|
|
|
|
|
|
Picture is too bright and | • | Image adjustments are incorrectly set. | 40 |
whitish. |
|
|
|
The cooling fan becomes | • | When temperature inside the projector increases, the cooling fan | – |
noisy. |
| runs faster. |
|
The lamp does not light | • | The lamp indicator is illuminating in red. |
|
up even after the |
| Replace the lamp. |
|
projector turns on. |
|
| 48, 51 |
The lamp suddenly turns |
|
|
|
off during projection. |
|
|
|
|
|
|
|
The image sometimes | • | Cables incorrectly connected to the projector or the connected |
|
flickers. |
| equipment works improperly. |
|
| • | Select “Vertical stripes or flickering image appear” in the “Help” | 46 |
|
| menu and make the necessary adjustments. |
|
| • | If this happens frequently, replace the lamp. | 51 |
|
|
|
|
The lamp needs much | • | The lamp will eventually need to be changed. | 51 |
time to turn on. |
| While the remaining lamp life draws to a close, replace the lamp. |
|
Picture is dark. |
|
|
|
|
|
|
|
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.
60
