Turning the Projector On/Off

Connecting the Power Cord

Supplied

Power cord

accessory

 

Plug the supplied power cord into the AC socket on the rear of the projector.

Turning the Projector on

Before performing the steps in this section, connect any equipment that you use with the projector. (See pages 23-28.)

Remove the lens cap and press on the

projector or on the remote control.

•The power indicator illuminates green.

•After the lamp indicator illuminates, the projec- tor is ready to start operation.

•When System Lock is set, the keycode input screen appears. Enter the right keycode to start projection. See page 54 for details. Note

•The lamp indicator illuminates or blinks, in- dicating the status of the lamp.

Green: The lamp is ready.

Blinking green: The lamp is warming up or shutting down.

Red: The lamp is shut down abnormally or the lamp should be replaced.

•When switching on the projector, a slight flicker- ing of the image may be experienced within the first minute after the lamp has been illuminated. This is normal operation as the lamp's control circuitry is stabilizing the lamp output charac- teristics. This does not indicate malfunction.

•If the projector is put into standby mode and immediately turned on again, the lamp may take some time to illuminate.

Info

•English is the factory preset language. If you want to change the on-screen display to another language, change the language according to the procedure on page 62.

 

ON button Power

 

indicator

STANDBY

Lamp

indicator

button

 

ON button

STANDBY button

▼On-screen Display

Operation Basic

Turning the Power off (Putting

the Projector into Standby Mode)

1

Press

on the projector or

 

on the remote control, then press

 

that button again while the confir-

 

mation message is displayed, to

 

put the projector into standby

 

mode.

 

2Unplug the power cord from the AC outlet after the cooling fan stops.

Info

•Do not unplug the power cord during projection or cool- ing fan operation. The cooling fan in this projector contin- ues to run for about 90 seconds after the projector enters the standby mode. This can cause damage due to rise in internal temperature, as the cooling fan also stops.

-29