Removing and Installing the Lamp Unit
Info
•Ensure the lamp unit is removed using the handle. Ensure the glass surface of the lamp unit or the inside of the projector are not touched.
•To avoid injury to yourself and damage to the lamp, ensure to carefully follow the steps below.
•Do not loosen other screws except for the lamp unit cover and lamp unit.
1 Press | on the projector or |
on the remote control to put the projector into standby mode.
•Wait until the cooling fan stops.
Warning!
•Do not remove the lamp unit from the projector right after use.The lamp and parts around the lamp will be very hot and may cause burn or injury.
2Disconnect the power cord.
•Unplug the power cord from the AC socket.
•Leave the lamp until it has fully cooled down (about 1 hour).
3Remove the lamp unit cover.
•Turn the projector over. Loosen the user service screw (1) that secures the lamp
unit cover. Pressing the tab, remove the lamp unit cover (2).
Optional | Lamp unit |
accessory | |
STANDBY button |
|
AC socket
1 |
| |
2 |
| |
Tab |
| |
Tab | Appendix | |
User service screw | ||
| ||
(for lamp unit cover) |
|