| Maintenance indicator | Problem | Cause | Possible solution | |||
|
|
|
| ||||
|
| Normal | Abnormal | ||||
|
|
|
|
|
| ||
|
|
|
|
|
| • Relocate the projector to an area | |
|
|
|
|
| • Blocked air intake | with proper ventilation (see page | |
| Temperature |
|
| The internal |
| 7). |
|
|
|
|
|
|
| ||
|
| Red on |
| • Take the projector to your nearest | |||
| warning | Off | temperature is | • Cooling fan break- | |||
| (Standby) | Sharp Authorized Projector Dealer | |||||
| indicator |
| abnormally high. | ||||
|
|
| down | or Service Center (see page 72) | |||
|
|
|
|
| |||
|
|
|
|
| • Internal circuit failure | for repair. | |
|
|
|
|
| • Clogged air intake | • Clean the exhaust and intake | |
|
|
|
|
|
| vents. (See page 63.) | |
|
|
|
|
|
|
|
|
|
|
|
| The lamp does | • The lamp is shut | • Disconnect the power cord from | |
|
|
|
| the AC outlet, and then connect it | |||
|
|
|
| not illuminate. | down abnormally. | ||
|
|
|
| again. | |||
|
| Green on |
|
|
| ||
|
| Red on |
|
|
|
| |
|
|
|
| • Carefully replace the lamp. (See | |||
|
| Green blinks | Time to change | • Remaining lamp life | |||
|
|
| page 67.) | ||||
| Lamp | when the lamp |
| ||||
|
| the lamp. | becomes 5% or less. | • Take the projector to your nearest | |||
| is warming up |
| |||||
| indicator |
|
|
| Sharp Authorized Projector Dealer | ||
| or shutting |
|
|
| |||
|
|
|
|
| or Service Center (see page 72) | ||
|
| down. | Red on | The lamp does | • | ||
|
|
| for repair. | ||||
|
|
| (Standby) | not illuminate. | • Lamp circuit failure | • Please exercise care when | |
|
|
|
|
|
| replacing the lamp. | |
|
|
|
|
|
|
|
|
Info
•If the temperature warning indicator illuminates and the projector enters the standby mode, check whether any of the ventilation holes are blocked (page 7) and then try turning the power back on. Wait until the projector has cooled down completely before plugging in the power cord and turning the power back on. (At least 10 minutes.)
•If the power is turned off for a brief moment due to power outage or some other cause while using the projector, and the power supply recovers immediately after that, the lamp indicator will illuminate in red and the lamp may not be lit. In this case, unplug the power cord from the AC outlet, replace the power cord in the AC outlet and then turn the power on again.
•Do not unplug the power cord after the projector has entered the standby mode and while the cooling fan is running. The cooling fan runs for about 90 seconds.
Appendix
-65