12/3/17 HF401PH_OM_EN.fm
10
9
8
7
6
5
4
3
2
1
E-4System connections
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
●The first time the unit is plugged in, the unit will enter
the demonstration mode (refer page 9).
●To cancel the demonstration mode, press the DEMO/
DIMMER button (remote control) during power stand-
by mode. The unit will enter the low power consumption
mode.
●If iPod or iPhone is docked, the unit will begin charging.
“Charge Mode” will displayed. Demonstration (Network
Stand-by) mode is invalid during charge mode.
●To return to the demonstration (Network Stand-by)
mode, press the DEMO/DIMMER button again.
Video files from iPod or iPhone can be viewed by
connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket at the back of the unit and set the TV Out on
the iPod or iPhone unit to “ON” position.
Note:
Please make sure to set iPod unit to either NTSC or PAL to
match your TV signal. Please visit Apple’s homepage for
further information.
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
Make sure to unplug the AC power lead before making any connections.
Right
speaker FM aerial
To video input socket
Video cable
(not supplied)
Red
Black
Left
speaker
TV
Wi-Fi aerial
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Turn the Wi-Fi
aerial upright
before operation.
■Aerial connection
■Speaker connection
●Connect the black wire to the
minus (–) terminal, and the red
wire to the plus (+) terminal.
●Use speakers with an impedance
of 4 ohms or more, as lower
impedance speakers can damage
the unit.
●Do not mistake the right and the
left channels. The right speaker is
the one on the right side when you
face the unit.
Incorrect
●Do not let the bare speaker wires touch each other.
●Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
●Do not stand or sit on the speakers. You may be
injured.