12/3/17 HF401PH_OM_EN.fm
10
9
8
7
6
5
4
3
2
1
E-24

Troubleshooting chart (continued)

Remove the iPod, iPhone, iPad, USB memory device and disc from
the unit. Then, set the unit to the power stand-by mode. Carrying the
unit with iPod, iPhone, iPad or USB memory device left connected
or discs left inside might damage the unit.
Compact discs are fairly resistant to damage, however mistracking can occur
due to an accumulation of dirt on the disc surface. Follow the guidelines below
for maximum enjoyment from your CD collection and player.
●
Do not write on either side of the disc, particularly the non-label side
from which signals are read. Do not mark this surface.
●
Keep your discs away from direct sunlight, heat, and excessive
moisture.
●
Always hold the CDs by the edges. Fingerprints, dirt, or water on the
CDs can cause noise or mistracking. If a CD is dirty or does not play
properly, clean it with a soft, dry cloth, wiping straight out from the
centre, along the radius.

Maintenance

Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
●Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
●
Do not apply oil to the inside of the unit. It may cause malfunctions.

Specifications

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There
may be some deviations from these values in individual units.

■Before transporting the unit

■Care of compact discs

■Cleaning the cabinet

NO YES
Correct
■General
Power source AC 220 - 240 V ~ 50/60 Hz
Power
consumption Power on: 40 W
Power stand-by: 0.4 W (*)
Dimensions Width: 215 mm (8 - 1/2")
Height: 96 mm (3 - 4/5")
136 mm (5 - 2/5") (with Wi-Fi
aerial upright)
Depth: 335 mm (13 - 1/5")
Weight 2.8 kg (6.2 lbs.)
( * )This power consumption value is obtained when the
demonstration mode is cancelled in the power stand-by
mode. Refer to page 4 to cancel the demonstration mode.

■Amplifier

Output power
PMPO: 200 W
MPO: 100 W (50 W + 50 W) (10% T.H.D.)
RMS: 100 W (50 W + 50 W) (10% T.H.D.)
RMS: 66 W (33 W + 33 W) (1% T.H.D.)
Output terminals Speakers: 4 ohms, 20Hz - 20kHz
Subwoofer Pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Video output: 1 Vp-p
Headphones: 16 ohms
(recommended: 32 ohms)
Input terminals Audio In (Audio signal):
500 mV/47 k ohms
Line in (Analogue input):
500 mV/47 k ohms

■CD player

Type
Single disc multi-play compact disc player
Signal readout Non-contact, 3-beam
semiconductor laser pickup
D/A converter Multi bit D/A converter
Frequency response
20 - 20,000 Hz
Dynamic range 90 dB (1 kHz)

■USB (MP3 / WMA)

USB host interface ●Complies with USB 1.1 (Full
Speed)/2.0 Mass Storage
Class.
●Support Bulk only and CBI
protocol.
Support file ●MPEG 1 Layer 3
●WMA (Non DRM)
Bitrate support ●MP3 (32 ~ 320 kbps)
●WMA (64 ~ 160 kbps)
Other ●Maximum total number of
MP3/WMA files is 65025.
●Maximum total number of
folders is 999 INCLUSIVE of
root directory.
●The ID3TAG information
supported are TITLE, ARTIST
and ALBUM only.
●Supports ID3TAG version 1
and version 2.
File system
support
●Support USB devices with
Microsoft Windows/DOS/FAT
12/FAT 16/ FAT 32.
●2 kbyte block length for sector.

■Tuner

Frequency range FM: 87.5 - 108.0 MHz
Preset 40 (FM station)

■Speaker

Type 2-way type speaker system
2.5 cm (1") Dome-Tweeter
12 cm (4-3/4") Woofer
Maximum input
power 100 W
Rated input power 50 W
Impedance 4 ohms
Dimensions Width: 148 mm (5-13/16")
Height: 262 mm (10-5/16")
Depth: 203.5 mm (8")
Weight 2.5 kg (5.4 lbs.)/each