Connecting to a Computer
Connecting to a Computer Using the DVI to
1 Connect a DVI to
2 Connect the above adaptor to an RGB cable.
3 Connect the above cable to the computer.
•Secure the connectors by tightening the thumbscrews.
Note
•Refer to “Computer Compatibility Chart” on page 66 for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.
•When connecting the projector to a computer in this way, select “RGB” for “Signal Type” on
the OSD menu or press on the remote control. (See page 52.)
•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp Authorised Projector Dealer or Service Centre.
•Depending on the computer you are using, an image may not be projected unless the signal output setting of the computer is switched to the external output. Refer to the computer op- eration manual for switching the computer sig- nal output settings.
Optional | DVI to |
accessory | |
| Type: |
To INPUT 2 terminal
DVI to
RGB cable (commercially available)
To RGB output terminal
Notebook computer
Connections and Setup
Connecting the thumbscrew cables
■ Connect the thumbscrew cable making sure that it fits cor- rectly into the terminal. Then, firmly secure the connec- tors by tightening the screws on both sides of the plug.
■ Do not remove the ferrite core attached to the RGB cable.
Ferrite core