Sharp XV-Z200E RS-232C Specifications and Command Settings, PC control, Communication conditions

(RS-232C) Specifications and Command Settings

PC control

A computer can be used to control the projector by connecting an RS-232C cable (null modem, cross type, commercially available) to the projector. (See page 23 for connection.)

Communication conditions

Set the serial port settings of the computer to match that of the table.

Signal format: Conforms to RS-232C standard.

Baud rate: 9,600 bps

Data length: 8 bits

Parity bit: None

Stop bit: 1 bit

Flow control: None

Basic format

Commands from the computer are sent in the following order: command, parameter, and return code. After the projector processes the command from the computer, it sends a response code to the computer.

Command format

C1 C2

C3

C4

P1

P2

P3

P4

Return code (0DH)

Command 4-digit

Parameter 4-digit

Response code format

Normal response

Problem response (communication error or incorrect command)

O

K

Return code (0DH)

E

R

R

Return code (0DH)

Info

•When more than one code is being sent, send each command only after the OK response code for the previous command from the projector is verified.

Note

•When using the computer control function of the projector, the projector’s operating status cannot be read by the computer. Therefore, confirm the status by transmitting the display commands for each adjustment menu and checking the status with the on-screen display.

Commands

Example:

•When power on.

Computer

P O W R _ _ _ 1

→

←

Projector

O K

		CONTROL CONTENTS	COMMAND				PARAMETER				RETURN
BUTTONS	POWER ON		P	O	W	R	_	_	_	1	OK OR ERR
CONTROL	STANDBY		P	O	W	R	_	_	_	0	OK OR ERR
	INPUT 1	(COMPONENT 1)	I	V	E	D	_	_	_	1	OK OR ERR
REMOTE	INPUT 2	(COMPONENT 2)	I	V	E	D	_	_	_	2	OK OR ERR
	INPUT 3	(S-VIDEO)	I	V	E	D	_	_	_	3	OK OR ERR
&	DIGITAL INPUT MODE		I	V	E	D	_	_	_	5	OK OR ERR
BUTTONS
	INPUT 4	(VIDEO)	I	V	E	D	_	_	_	4	OK OR ERR

Note

•If an underbar (_) appears in the parameter column, enter a space.

Appendix

-65