Sharp XV-Z200E operation manual Important Safeguards

IMPORTANT SAFEGUARDS

Be sure to read the following safeguards when setting up your projector.

Caution concerning the lamp unit

■There is a potential hazard of glass particles if the lamp ruptures. In case of lamp rupture, contact your near- est Sharp Authorised Projector Dealer or Service Centre for replace- ment.

See “Replacing the Lamp” on page 59.

CAUTION

PRECAUCIÓN

PRÉCAUTION

BQC-XVZ200++1

■If the cooling fan becomes obstructed, a protection device will automatically turn off the projector lamp. This does not indicate a malfunction. Remove the projector power cord from the wall outlet and wait at least 10 minutes. Then turn on the power by plugging the power cord back in. This will return the projector to the normal operating condition.

Cautions regarding the transportation of the pro-

Cautions concerning the setup of the projector

■For minimal servicing and to maintain high image qual- ity, SHARP recommends that this projector be installed in an area free from humidity, dust and cigarette smoke. When the projector is subjected to these environments, the lens and part of filter must be cleaned more often than usual. As long as the projector is properly main- tained in this manner, use in these environments will not reduce the overall operation life. Please note that all internal cleaning must be performed by a Sharp Authorised Projector Dealer or Service Centre.

Do not set up the projector in places exposed to direct sunlight or bright light.

■Position the screen so that it is not in direct sunlight or room light. Light falling directly on the screen washes out the colours, making viewing difficult. Close the cur- tains and dim the lights when setting up the screen in a sunny or bright room.

Do not subject the projector to hard impact and/ or vibration.

■Take care with the lens so as not to hit or damage the surface of the lens.

Rest your eyes occasionally.

■Watching the screen for long hours continuously will make your eyes tired. Be sure to occasionally rest your eyes.

Do not expose the projector to extreme heat or cold.

■ Operating temperature: +5°C to 35°C

+35˚C

■ Storage temperature: –20°C to +60°C

+5˚C

Notes on Operation

■The exhaust ventilative holes, the lamp unit cover and adjacent areas may

get extremely hot during projector operation. To pre- vent injury, do not touch these areas until they have sufficiently cooled down.

■Allow at least 30 cm of space between the exhaust ventilative hole and the nearest wall or obstruction.

jector

■When transporting the projector, be sure not to subject it to hard impact and/or vibration, as this can result in damage. Take extra caution with the lens. Before mov- ing the projector, be sure to unplug the power cord from the wall outlet, and disconnect any other cables con- nected to it.

Other connected equipment

■When connecting other audio-visual equipment or a computer to the projector, make the connections AF- TER turning off the projector and the equipment to be connected.

■Please read the operation manuals of the projector and the equipment to be connected for instructions on how to make the connections.

Temperature monitor function

■If the projector starts to overheat

due to setup problems or blockage of the air vents, “ ” and

“ ” will blink in the lower left corner of the picture. If the tem-

perature continues to rise, the lamp will turn off, the temperature warning indicator on the projector will blink, and after a 90-second cooling-off period the projector will enter the standby mode. Refer to “Maintenance In- dicators” on page 58 for details.

Info

•The cooling fan regulates the internal temperature, and its performance is automatically controlled. The sound of the fan may change during projector operation due to changes in the fan speed. This does not indicate malfunction.

-6