Sherwood R-671 manual Tuning to preset stations, Memory Backup Function

Select the desired preset number	4	Repeat the above steps ① to ③ to
3 button.(1~30) and press the MEMORY/ENTER		memorize other stations.

• The station has now been stored in the memory.		■MEMORY BACKUP FUNCTION
• A stored frequency is erased from the memory		The following items, set before the receiver is
	by storing another frequency in its place.	turned off, are memorized.
• If “MEM” goes off, start again from the above		• INPUT SELECTOR settings
	step ②.	• Surround mode settings
		• Preset stations,etc.
			Select the desired preset number.
	Tuning to preset stations	2
	After selecting the tuner as an input
	1 source, select the preset tuning mode.

• Then “PRESET” lights up.	• When pressing the PRESET +/- buttons on the
	remote control, you need not select the preset
	tuning mode on step ①.

Listening to FM stereo broadcasts Scanning preset stations in sequence

• While listening to FM broadcasts.

• Each time this button is pressed, the FM mode changes as follows;

	• The receiver will start scanning the stations in the
• When FM stereo broadcasts are poor because	preset sequence and each station is received for 5
	seconds.
of weak broadcast signals, select the FM mono	• At the desired station, press this button again to
mode to reduce the noise, then FM broadcasts	stop scanning.
are reproduced in monaural sound.

35