3 Press the ENTER button to start the auto speaker setup procedure.
•Loud test tones are output from each speaker and then if the auto speaker setup procedure has been completed, the results of each adjustment will be displayed.
•To stop the auto speaker setup procedure while outputting the test tones, press the ENTER button.
•If the polarity is incorrect,
•If there may be a problem with the speaker or microphone connection, “▶▶ ERROR ◀◀” message will be displayed.
•When “▶▶ ERROR ◀◀” message is displayed, press the CURSOR RIGHT(▶) button to retry the auto speaker setup procedure.
•If retrying the procedure dose not fix the problem, turn off the power and check the speaker or microphone connections.
■Notes :
•For details on speaker size, crossover frequency and speaker distance, refer to “About the speaker size” and “About the speaker distance” on page 18.
•Because the test tones are very loud, ensure there no infants or small children in the room.
•It is possible to lower the volume of the test tomes, but this could result in incorrect speaker settings.
•For best results, ensure the room is as quiet as possible during the auto speaker setup procedure. If there is too much ambient noise, the results may not be satisfactory.
•If the results are not satisfactory, set the speaker setup manually. (For details, refer to “When selecting the MANUAL SPEAKER SETUP” on page 42)
Confirm the results.
4
• Then the results are memorized.
When selecting the MANUAL SPEAKER SETUP
1 | Press the CURSOR UP(▲)/DOWN(▼) buttons to select the MANUAL SPEAKER SETUP, |
then press the ENTER button. |
42
