47

SETTING THE CH LEVEL SETUP

Notes :
• Depending on the speaker settings and surround mode, etc., some channels cannot be selected.
• When the SPEAKER button is set to off, only the Front Left and Right channels can be selected.
• Only when the digital signals from Dolby Digital or DTS program sources that include LFE signal are input, “DD L”(Dolby
Digital LFE) or “DTS L” can be selected.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into
user’s memory(“USER”), not into preset memory(“REF. 1”, “REF. 2”)
• After adjusting each channel level with test tone, adjust the channel levels either according to the
program sources or to suit your tastes.(For details, refer to “Adjusting each channel level with test tone”
on page 31.)
• The LFE level can be adjusted within the range of -
10 ~ 0 dB and other channel levels within the range
of -15 ~ +15 dB
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower setting
as necessary.

Adjusting the current channel level

Press the CURSOR UP( )/DOWN( ) buttons to select the desired channel.
1
Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the level of the selected channel as
desired.
2
Repeat the above steps and to adjust each channel level.
3
DEVICE SELECT
VOLUME
TUNER CD AUX TAPE
VIDEO1 VIDEO2 VIDEO3
EXT.IN
AUD