Sherwood R-765 manual Using Functions Of Remote Control, Entering a setup code

USING FUNCTIONS OF REMOTE CONTROL

•This remote control can control up to 8 different components.

•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.

•For system remote control operation, “000” was stored previously in the memory of the device button “CD” for Sherwood CD player, “DVD” for Sherwood DVD player and “AUX” for Sherwood tape deck respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.

Entering a setup code
1	Turn on the component you want to control	2	Find the setup codes according to the type
			and the brand name of your component,
			referring to “Setup Code Table” on page 42.

3	Press and hold down both the ENTER	4		Enter a 3 digit code, aiming the remote control
	button and the DEVICE button you want			at the remote sensor on the component.
	for more than 1 second.			Example) When entering “001”.
	DEVICE			1	2	3	4
	buttons			5	6	7	8
		0	0	1
				9	0	+10
	T/V
					MACRO
				M1	M2	M3
		• If entering is performed successfully, the LED will
	ENTER	flicker twice.
		• To be sure that the setup code is correct, press the
		POWER(or STANDBY) button.
		If your component is tuned off, the setup code is correct.
• The LED will flicker once.		• When your component is not turned off, repeat the
		above steps 2 to 4, trying each code for your component
Note:		until you find one that works.
• The AUDIO button is unavailable for the audio		Notes:
components other than this receiver.
		• If the LED did not flicker twice, then repeat the above
		steps 3 to 4 and try entering the same code again.
		• Manufacturers may use different setup codes for the
		same product category. For that reason, it is important
		that you check to see if the code you have entered
		operates as many controls as possible. If only a few
5	Repeat the above steps 1 to 4 for each of	functions operate, check to see if another code will
	your components.	work with more buttons.
		• When operating a Sherwood CD player or tape deck
		using the system remote control, aim the remote
		control at the REMOTE SENSOR on this receiver.
		However, in case of Sherwood DVD player and MD
		recorder, aim it at the REMOTE SENSOR on the
		corresponding component.

16