Sherwood R-765 manual

ENJOYING SURROUND SOUND
1	Depending on the input digital signal format, select the desired decoding mode.
					• Each time the AUTO button is pressed, the decoding
					mode changes as follows :
AUTO	SURROUND MO				IN-AUTO : The input digital signal format(DTS, Dolby
					Digital or PCM(2 channel stereo), etc.) used
				AUTO	by the selected digital input source is detected
	or				automatically to perform the necessary
					decoding process for optimum surround mode.
	1	2	3	4	IN-DTS : The DTS signal processing is performed only
					when DTS signals are input.
	5	6	7	8	IN-PCM : The PCM signal processing is performed only
					when PCM signals are input.

Notes :

•Only when the digital input is selected as signal input for the input sources except TUNER, TAPE and AUX, the decoding mode can be selected.

•Noise may be generated at the beginning of playback and while searching during DTS playback in the IN-AUTO mode. In this case, try playing in the IN-DTS mode.

2	Select the desired surround mode.
		SURROUND MODE
		DSP MODE
						DSP <, >
			or
			1	2	3	4
			5	6	7	8
• Each time the DSP MODE		(<) or	(>) button is pressed, the surround mode changes depending on the input signal
format and the selected decoding mode as follows :
Signal format being input			Selected decoding mode		Selectable surround mode
Dolby Digital EX 6.1 channel sources			IN-AUTO mode		DOLBY DIGITAL EX, DOLBY VIRTUAL
Dolby Digital 5.1 channel sources			IN-AUTO mode		DOLBY DIGITAL, DOLBY VIRTUAL
Dolby Digital 2-channel			IN-AUTO mode		PL II MOVIE, PL II MUSIC,
sources					PRO LOGIC, DOLBY VIRTUAL
PCM(2 channel) sources			IN-AUTO, IN-PCM mode		PL II MOVIE, PL II MUSIC, PRO LOGIC,
Analog stereo sources					DOLBY VIRTUAL, NEO 6 CINEMA, NEO 6
					MUSIC, THEATER, HALL, MATRIX
DTS sources			IN-AUTO, IN-DTS mode		corresponding DTS mode

•When the analog input is selected as signal input and analog stereo signals are input, you can select the desired of these above surround modes, too.

•However, when DTS signals are input in the IN-AUTO or IN-DTS mode, the corresponding DTS mode will be

selected regardless of using the DSP MODE (<) or (>) button. Notes:

•When the selected decoding mode is not matched to the input signal format, the “DIGITAL” indicator flickers and no sound is heard. Therefore, be sure to select the required decoding mode and the available surround mode according to the input signal format.

•When the 7 CH DIRECT is selected as an input source, the decoding and surround modes cannot be selected.

•When the digital signals are not inputted, the desired surround mode cannot be selected.

27