Sherwood R-765 manual Tuning to preset stations, Memory Backup Function

3	Select the desired preset number (1~30) and		4	Repeat the above steps 1 to 3 to memorize
	press the below button.			other stations.
	TUNING/PRESET	MEMO/ENTER

		MEMORY BACKUP FUNCTION
		The following items, set before the receiver is turned
PRESET +	ENTER	off, are memorized.
PRESET -		• INPUT SELECTOR settings
		• Surround mode settings
		• Preset stations,etc.
• The station has now been stored in the memory.		Note : If the electricity fails or the AC input cord is
• A stored frequency is erased from the memory by		disconnected for more than 2 weeks, they are all
storing another frequency in its place.		cleared. So you should memorize them again.
• If “MEM” goes off, start again from the above step 2.
Tuning to preset stations		2	Select the desired preset number.
1	After selecting the tuner as an input
	source, select the preset mode.
	T/P MODE	TUNING/PRESET
			or	PRESET +
				PRESET -
• Then “PRESET” lights up.		• When pressing the PRESET +/- buttons on the
		remote control, you need not select the preset mode
		on step 1.
Listening to FM stereo broadcasts		Scanning preset stations in sequence

• While listening to FM broadcasts.

FM MODE

P.SCAN

• Each time this button is pressed, the FM mode changes as follows;

	Stereo mode : “ST” lights up.	• The receiver will start scanning the stations in the preset
	Mono mode : “ST” goes off.
		sequence and each station is received for 5 seconds.
• When FM stereo broadcasts are poor because of weak		• At the desired station, press this button again to stop
		scanning.
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound.

33