Sherwood V-768 user service Changing the Video Signal, Changing the Component Video

ENGLISH

CHANGING THE VIDEO SIGNAL

•Depending on the countries, this unit conforms to either the NTSC color system for U.S.A, Canada, etc., or the PAL for Europe, Australia, China, etc.

If the color system of this unit is different from that of your TV monitor and the discs to be played, the screen may be somewhat hard to see or the picture quality may be poor.

Only in this case, change the video signal format to another.

(For details about the video signal format of your TV monitor or the discs, refer to the operating instruction of your TV or the disc’s jacket.)

•You can set the video signal format to the desired at initial settings, too. (For details, refer to “SETTING THE VIDEO SETUP” on page 32.)

• In the stop mode, press the NTSC/PAL button.

RC

•Each time this button is pressed, the video signal format changes as follows:

AUTO NTSC PAL

•The AUTO is compatible with both NTSC and PAL formats.

CHANGING THE COMPONENT VIDEO

•When the COMPONENT VIDEO OUTs of this unit are connected to the COMPONENT VIDEO INs of TV or projector, etc., depending on whether the video signal system of your TV or projector, etc. supports the conventional interlacing(simply called interlaced) video signals or the progressively scanned(simply called progressive) video signals(that can reproduce high-density pictures with less flicker), you should select the corresponding video signal.

•You can set the component video output signal to the desired at initial settings, too. (For details, refer to “SETTING THE VIDEO SETUP” on page 32.)

Notes:

•When you select the progressive video signal, the S-VIDEO and COMPOSITE VIDEO OUTs of this unit cannot output the normal video signals. Therefore, it causes the picture to break up and shake.

•When the progressive video signals are input into the non-progressive COMPONENT VIDEO INs of your TV, etc., the picture may not be shown normally, too.

Therefore, when the progressive COMPONENT VIDEO INs of TV is not connected to, you should select the interlaced video signal.

•Press the PROGRESSIVE SCAN button.

RC	• Each time this button is pressed, the component
PROGRESSIVE	video output signal changes and “INTERLACED
SCAN	TV” or “PROGRESSIVE TV” is displayed on the TV
	screen.

26