Sherwood V-768 user service Setting the Audio Setup, When selecting the Digital OUT

SETTING THE AUDIO SETUP

•When the DIGITAL OUTs of the unit are connected to the corresponding DIGITAL INs of an amplifier with built- in decoder, MD/CD recorder, etc., these items should be set correctly.

ENGLISH

Tilt the CURSOR/ENTER button upward or downward to select the preferred item, then press the

1 CURSOR/ENTERRC	button. RC
	• Then the selected item screen is displayed.

When selecting the DIGITAL OUT

Notes :

•When the DIGITAL OUT of the unit is connected to the DIGITAL IN of an amplifier which does not contain the Dolby Digital or MPEG-II decoder(which processes the bitstream signal), you should set the DIGITAL OUT to LPCM to convert Dolby Digital or MPEG bitstream to linear PCM(2 channel) of 48 kHz/16 bit and to output it.

•If the DIGITAL OUT is not set correctly, loud noise or no sound may be heard from the speakers, and it may be harmful to your ears and damage the speakers.

RC

When selecting the LPCM SELECT

This setting is valid when the DIGITAL OUT is set to BITSTREAM or LPCM.

Notes:

•When connecting to the DIGITAL IN of an MD or CD recorder for digital recording, you should set the LPCM SELECT to LPCM 48K. If not, the digital recording does not perform properly.(Digital output of PCM audio is restricted to 48 kHz/16 bit or below for copyright protection.)

•Because the audio recording format of the MD or CD recorder is the linear PCM, the digital recording of the Dolby Digital, DTS and MPEG bitstream signal cannot be performed.

•When connecting to the DIGITAL IN of an amplifier which does not process high frequency signals of 96 kHz, you should set the LPCM SELECT to LPCM 48K. If not, no sound may be heard from the speakers.

35