Assembly
Throttle Cable Free Play Adjustment
1.Move the throttle lever to check for smooth operation. Any stiffness or bind- ing must be corrected before using the product.
2.Actuate the throttle lever to check for free play of approximately
Temporarily move the adjuster cover to expose the cable adjuster. See Figure 8.
Loosen the cable locknut and then screw the cable adjuster in or out until proper free play is achieved. See Figure 9.
Adjusting Free Play |
|
|
Adjuster Cover |
| Cable |
|
| Locknut |
| 26109 | Cable |
| Adjuster | |
Figure 8 |
| |
|
|
26110 | |
| Free Play |
Figure 9
Assembly
Handle
Throttle Lever | Handle |
Housing |
|
|
| Hex Nut |
Mounting Screw | Washer | Hex Nut |
|
| |
About 10 |
| 26115 |
|
| |
inches |
|
|
| Washer |
|
| Adjustment | Outer Tube |
Figure 10 | Knob |
|
Connect the Handle to the
Outer Tube.
1.Remove both screws from the handle.
2.While spreading the handle at the mounting hole, position the handle on the outer tube. See Figure 10.
3.Reinstall the two mounting screws in the handle, but do not tighten them at this time.
NOTE:
The handle is recessed to receive the hex nuts.
4.Locate the handle at the best position for operator comfort (usually about 10 inches ahead of the throttle lever). See Figure 10.
5.Secure the handle by tightening the knob at the handle base.
