Shindaiwa T2510 Cutting Attachment Shield T, TX unit, Sub-Shield When trimmer head is in use

Assembly (continued)

Cutting Attachment Shield - T, TX unit

1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate.

NOTE:

It may be necessary to loosen the retain- ing nut and clamp screw to adjust cutting attachment shield mounting plate.

2.Fit the two shims and the bracket over the outer tube and loosely install the four socket-head screws.

3.Tighten the four socket-head cap screws to secure the cutting attach- ment shield.

CAUTION!

Make sure the clamp screw and retaining nut are securely tightened before tightening the four socket- head cap screws.

WARNING!

NEVER operate the unit with- out the cutting attachment shield installed and tightly secured!

Sub-Shield

(when trimmer head is in use)

1.Attach the shield extension to the cutting attachment shield.

WARNING!

NEVER use this machine with- out sub-shield when using a trimmer head.

CAUTION!

Make sure the sub-shield is completely hooked at the hook receiver.

		T unit
Socket-
Head Cap		Outer Tube
Screws	Bracket
Shim		Cutting Attachment
		Shield
Clamp Screw
	Shim	Line Cutter
Mounting	Plate
Retaining
Nut

TX unit

Socket-Head	Bracket	Outer Tube
Cap Screws

Shim

Clamp Screw

Shim

Mounting Plate

Retaining

NutCutting Attachment

Shield w/subshield

Line Cutter

Cutting Attachment Shield

Hook Receiver

Sub-shieldHook

Attach the sub-shield to the cutting attachment shield for TX units when using a trimmer head

7