Shure VP manual T2 or EC2 Hand-Held Microphone-Transmitter Figure

T2 or EC2 Hand–Held Microphone–Transmitter (Figure 10)

1.Grille: Protects the microphone and helps reduce breath sounds and wind noise.

2.Antenna: The EC2 microphone-transmitter includes an external helical antenna with a miniature female coaxial connector. The T2 includes an internal antenna comprised of the 9 V battery case and the printed–circuit board ground plane.

3.MICROPHONE ON/OFF Switch: Mutes the microphone without turning the trans- mitter off, so no “pop” or “thump” sounds occur when the microphone is turned on and off. Also prevents the receiver from picking up unwanted signals.

4.POWER ON/OFF Switch: Turns transmitter on and off.

5.Battery Test Indicator: Illuminates when the POWER switch is turned on and a “good” battery is installed.

6.Battery Compartment: Unscrewing the handle and sliding it downward exposes the battery compartment and audio GAIN Switch (8).

7.Frequency Identification Label: Located inside the battery compartment, this la- bel lists the transmitter’s operating frequency.

8.Audio HI/LO GAIN Switch or Control: Controls the audio level of the micro- phone.

9.Low Battery Indicator (T2 Only): Red light glows when one hour or less of useful operating tie remains; when this light glows, change the battery at the first opportunity.

T1 or EC1 Body–Pack Transmitter (Figure 11)

1.Microphone Jack: The microphone cable or the WA310 microphone adapter cable plugs into this connector.

2.Battery Test Indicator:Glows when the POWER switch is turned on and a “good” battery is installed.

3.MICROPHONE ON/OFF Switch: Mutes the microphone without turning the trans- mitter off, so no “pop” or “thump”sounds occur when the microphone is turned on and off.

4.POWER ON/OFF Switch: Turns transmitter on and off.

5.Antenna: A flexible antenna wire is permanently attached to the bottom of the body-pack transmitter. For proper operation, the antenna must be in the vertical position, not coiled or bundled.

6.Audio Level Control: Allows audio level adjustments for various sound sources. A small screwdriver is supplied to make adjustments.

7.Belt Clip: Allows the transmitter to be worn on a belt or waistband.

8.Battery Compartment: Hinged cover on bottom surface exposes the battery compartment.

9.Low Battery Indicator (T1 only): Red light glows when one hour or less of useful operating time remains. When this light glows, change the battery at the first op- portunity.

10.Lavalier Microphone:WL93 subminiature omnidirectional microphone shown.

11.Microphone Mounting Clip: Holds the lavalier microphone so it can be attached to your clothing.

English – 8 – English