1015N-2MFM-1A
11.Install the 1015N-2M Modem Card (9) on top of the 1010N-2 module (7) carefully engaging connector P1 on the 1015N-2M with its mate P1 on the 1010N-2 module. Secure the 1015N- 2M by engaging its four captive screws with the four standoffs on the 1010N-2 module.
12.Install the large threaded cover mount standoff (10) from the mounting kit through the hole at the center of the 1015N-2M Modem Card (9) and into the threaded receptacle on the shield (5) previously installed in Step 7.
13.Referring to installation drawing 1015N-2M-7 (see Appendix A), plug telephone jack into J4 of the Modem Card. Thread the telephone line plug through one of the System 1010 flowmeter access holes and plug it into a standard telephone outlet (refer to paragraph
5.3below for communication connection options).
14.Replace Access Cover and finger tighten captive thumbscrew (12).
15.Place the 1010 flowmeter power switch to the ON position.
16.Close the 1010 flowmeter top cover by locking the cover latch.
17.Proceed to paragraph 5.2 to set 1010N flowmeter RS-232 parameters.
5.1.2OPTION 2 INSTALLATION PROCEDURE (Mounting Kit 1015N-2M-MK2) 1010N-2 Module only in 1010N/DN Type System
(Refer to Installation Drawing 1015N-2M-MK-7 sheet 2 of 3)
DISASSEMBLY (see Figure 2 and Figure 4)
1.Referring to Figure 2 above, open the 1010 NEMA flowmeter top cover by releasing the cover latch.
2.Place the power switch to the OFF position.
3.Loosen the captive thumbscrew securing the Access Cover and remove Access Cover.
CAUTION: Do not connect a serial data cable to J1 on the 1015N-2M Modem Card or damage to the Modem Card and flowmeter may result.
4.Loosen the four captive screws (1) at the corners of the 1010N-2 module (2) and carefully lift out the module disengaging it from the connector on the 1010N-1 module.
ASSEMBLY (see Figure 4)
5.Remove four captive screws (1) from the 1010N-2 module (2) loosened in Step 4 above. Install standoffs (3) from the mounting kit in the vacant positions.
6.Install the 1010N-2 module (2) carefully engaging connector P1 to the 1010N-1 module. Secure module by threading the four standoffs (3) installed in Step 5 above with their mates on the 1010N-1 module.
7.Check for properly alignment of P1.
8.Install the 1015N-2M Modem Card (4) on top of the 1010N-2 module (2) carefully engaging connector P1 on the 1015N-2M with its mate P1 on the 1010N-2 module. Secure the 1015N- 2M by engaging its four captive screws (1) with the four standoffs (3) on the 1010N-2 module.
