Siemens 150, C100 DECT Appendix, Care, damp, Never, when …, Appendix, around 2 sec, Possible cause, What has happened, Possible solution, Contact with liquid, Questions and Answers

Appendix

Appendix

Care

Wipe the base and the handset with a damp cloth (use no solvent) or an antistatic cloth. Never use a dry cloth as this can cause static discharge!

Contact with liquid !

If the handset should come into contact with liquid, on no account switch the device on. Remove all batteries immediately.

Allow the liquid to drain out of the device, and then pat all parts of the device dry.

Keep the handset with the batteries removed in a warm, dry place for at least 72 hours. In many cases, you will then be able to use it again.

Questions and Answers

If you have any questions about the use of your phone, you can contact us 24/7 at www.my-siemens.com/customercare. You will find the most frequently asked questions and answers below.

What has happened	Possible cause	Possible solution
when …
… the display is blank?	The handset is not switched on.	Press the 'end call' key afor
	The batteries are flat.	around 2 sec..
		Charge or replace the batteries
		(page 9).
… the handset fails to respond	The keypad lock is activated.	Press the hash key Rfor
to a key press?		around 2 sec. (page 10) to
		deactivate the lock.
… "Base x" flashes in the dis-	The handset is outside the range	Move the handset nearer to the
play?	of the base.	base.
	The base is not switched on.	Check the power connector at
		the base (page 7).
… an internet address appears	The automatic registration of	Register your handset manu-
in the display?	your handset to the base has	ally (page 53).
	been interrupted.
… (when using more than one	The base will not charge the	Use an additional charger.
handset) the handset that is in	handset if telephoning is simul-
the base does not charge?	taneously in progress.
… the handset or the base	The ringer is switched off.	Switch on the ringer in the
C 150 does not ring?		handset (page 59) or base
		C 150 .
	Call Diversion is set to All Calls.	Switch off Call Diversion
		(page 20).
… I can hear no ringer tone/	You have changed the telephone	When purchasing a new cord
dial tone?	cord on your Gigaset.	ensure that it has the correct
		pin assignment (page 7).
… the other party cannot hear	You have pressed the INT key.	Switch on the microphone
me?	This mutes the handset.	again (page 18).

69