eWON4002™
Installation Guide
ver 2 . 04
5.4 Serial ports
The eWON4002™ is provided with 3 serial ports, 2 of which (port 1 and port 3) are configurable (RS485, RS422, RS232), and one (port 2) is a full RS232 (with all control lines present).
5.4.1 Serial port #1
Specification |
| Value |
|
|
|
Physical modes (configurable) |
| RS232/RS485/RS422 |
Normal isolation |
| |
| Optocoupler 1kV | |
|
| |
|
|
|
Pinout connector |
| See label and appendix (Relays output on page 30) |
Termination/polarization |
| Selectable |
| Table 9: Serial port 1 specification | |
The configuration of the physical serial port 1 mode is done by a set of 4 dip switches that are located on the left face from the unit. The settings of the switches are shown in the table below (note: please don’t forget that switch 1 is the most right one on the dip switch panel that matches serial port 1: the dip switch panel stands at the bottom right from the eWON®’s left face, just beside the serial port 1 connector, which stands at the bottom left from the eWON®’s front face)
Serial port 1
Serial port 1
dip switch
Figure 9: Serial port 1 connector and dip switch
page 13 of 35
