
eWON4002™
Installation Guide
ver 2 . 04
5.6.2 Relays
The 2 relays are on the
Specification | Value | |
|
| |
Number of outputs | 2 | |
|
| |
Type of output | SPST NO relays (Single Pole, Single Throw, | |
Normally Open) | ||
| ||
|
| |
Input voltage max | 24 VDC/24 VAC | |
|
| |
Max current (external source) | 1A | |
|
| |
Isolation | 1 kV | |
|
| |
Pinout connector | See label and appendix (Input/Outputs on page 28) | |
|
|
5.7 Analog Inputs
There are 6 Analog Inputs available, 4 of them are configurable in
5.7.1 Configurable standard Analog Inputs (AI1 - AI4)
The selection of Analog Input range is done by a dip switch located above the Analog Inputs connector (rear switch):
Figure 12: Rear switch panel and label (the label stands on the left side from the eWON®)
•To configure a channel to voltage input, place the matching switch to OFF.
•To configure a channel to current input, place the matching switch to ON.
page 18 of 35