eWON4002™
Installation Guide
ver 2 . 04
5.4.3 Serial port #3
Specification |
| Value |
|
|
|
Physical modes (configurable) |
| RS232/RS485/RS422 |
|
|
|
Normal isolation |
| NOT ISOLATED |
|
|
|
Pinout connector |
| See label and appendix (Relays output on page 30) |
|
|
|
Termination/polarization |
| Selectable |
|
|
|
| Table 12: Serial port 3 specification | |
The configuration of the physical serial port 3 mode is done by a set of 4 dip switches that are located on the bottom face from the unit. The settings of the switches are shown in the table below (note: when you look the bottom face from the eWON® with its front face at your right hand, then switch 1 is the leftmost switch on the dip switch panel that matches serial port 3: this dip switch panel stands at the right part from the eWON®’s bottom face, below the serial port 3 connector, which stands at the bottom right from the eWON®’s front face, just below serial port 2).
Serial port 3
Serial port 3
dip switch
Figure 10: Serial port 3 connector and dip switch
page 15 of 35
