Siemens eWON4002 manual Digital Outputs, Open collector Digital Output

Models: eWON4002

1 38
Download 38 pages 8.58 Kb
Page 20
Image 20

eWON4002™

Installation Guide

ver 2 . 04

5.6 Digital Outputs

There are 3 Digital Outputs: 1 open collector and 2 relays.

5.6.1 Open collector Digital Output

The open collector output is located on the Input/Output connector, which stands beside the power supply connector.

Specification

Value

 

 

Type of output

Open collector

 

 

Max current (external source)

200mA @ 30 VDC

 

 

Isolation

3,5 kV

 

 

Pinout connector

See label and appendix (Input/Outputs on page 28)

 

 

Table 15: Open collector Digital Output specification

This Digital Output is activated by an open collector transistor driven by an optocoupler. The maximum current flow into this transistor has a characteristic above the value specified in the eWON®, in order to cope with the switching power losses. The transistor used is of open collector type with pre drive. This means the relay power supply has to be supplied from an external source to the pre drive electronics.

The diagram below shows the external wiring needed for correct operation of the Digital Output. A relay has been chosen for this sample application but any load within the specifications can be used instead.

Warning: note that this is a sink only output to ground (the transistor acts like a switch to ground).

Figure 11: Digital output: wiring diagram

page 17 of 35

Page 20
Image 20
Siemens eWON4002 manual Digital Outputs, Open collector Digital Output