Installing the software and device drivers
i | If a dialog box appears during installation informing you about a missing |
signature, click Yes to continue the installation. | |
|
|
ìAfter installation of the software components, click on Finish to confirm completion of the installation procedure.
You then need to reboot your PC. You can only set up the Gigaset M34 USB PC adapter after rebooting.
ìClick on Yes to reboot the PC.
After restarting, installation is continued automatically. You are prompted to connect the Gigaset M34 USB PC adapter to the PC and the driver software is then installed. Later, you should register the Gigaset M34 USB PC adapter on your base station and you can then use the full range of functions of the software.
ìConnect the Gigaset M34 USB to a free USB port on your PC.
ìWhen you connect the Gigaset M34 USB, hardware recognition is started. This fea- ture monitors the installation of new device drivers. Depending on the previous con- figuration of your PC, it may be necessary to install several drivers for you Gigaset M34 USB PC adapter. Hardware recognition is started automatically for each driver installation.
–Follow the hardware recognition instructions.
–Confirm the preset options with Continue or Finish.
If you cancel hardware recognition, the driver software cannot be correctly installed.
ìWait until the hardware recognition procedure has completed installation of the device drivers.
ìIn the Setup Wizard, click on Finish to complete the installation.
ìReboot your PC if you are prompted to do so.
12