10 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1072 • September 2008
RTIF1-
070914-025
When you execute XCP Sync on the Firmware
Update page, after 15 minutes, the error
message "Another flashupdate is now
processing" or "The page cannot be displayed"
may appear.
There is no workaround. However, the XCP
Sync process has been continuously executed.
Check the XSCF update completion message
on the monitoring message to confirm the
completion of Sync process.
RTIF1-
071102-002
The snmp daemon might quit. To restart the snmp daemon, issue the
command setsnmp enable.
RTIF1-
071116-001
After using the addfru(8) or replceafru(8)
command for active replacement without the
diagnostic test in the maintenance menu,
further DR operation might fail with a
misleading message regarding the board being
unavailable for DR.
Do not fail to execute the diagnosis in the
maintenance menu of the addfru(8) or
replacefru(8) command. In case of missing
the diagnostic test in the maintenance menu of
the addfru(8) or the replacefru(8)
command, execute the testsb(8) command or
delete the CPU/memory board unit using the
deletefru(8) command and then retry the
addfru(8) command.
RTIF1-
071116-005
While system power on, when the XSCF
switching performed by switchscf(8)
command, PANIC might be generated in XSCF
before it switches, and "SHUTDOWN timeout"
may be stored in the error log.
There is no workaround. This message can be
safely ignored.
RTIF1-
071126-002
When the server is being installed, and the
mainline switch is turned on for the first time,
these error messages might be displayed:
PSU shortage
XSCF watchdog timeout
XSCFU hang-up is detected
XSCF process down detected
Turn off the system AC power, then turn it on
again.
When the error log is displayed again, turn off
the system AC power, then turn it on again. To
turn on the system power that you turned off,
wait at least 30 seconds before power-on.
RTIF1-
071129-003
An error log cannot be registered in XSCF
when the following message is displayed on
Solaris OS by the External I/O Expansion Unit
error:
SUNW-MSG-ID: SUN4-8000-4P, TYPE:
Fault
There is no workaround.
RTIF1-
080404-002
When you use the command setsnmpusm
passwd to set a password, if you set a
password of fewer than eight characters, a
segmentation fault occurs.
Always set a password of at least eight
characters.
TABLE3 XCP Issues and Workarounds (Continued)
ID Description Workaround