SIEMENS se5880 Ethernet Security Router | Chapter 3 Easy Setup |
User’s Guide | Untrusted Interface Configuration |
|
|
Using PPPoE
If you selected Using PPPoE from the Untrusted Interface Configuration page, perform the following steps to configure
1.Enter PPPoE User Name and Password to use for authentication when establishing a WAN connection using PPoE protocol.
2.In Service Name, enter the domain name of your network service provider. Use * as a default (for all services).
3.In PPPoE Timer, enter the number of seconds of inactivity that must elapse before the PPP connection closes. This helps to limit connection charges from your service provider during times of inactivity. The default entry of “permanent” will keep the PPP connection open constantly, with no timeout interval.
4.Optionally select NAT Enabled. THis enables Network Address Translation (NAT), which allows multiple workstations on your LAN to share a single, public IP address. All outgoing traffic appears to originate from the router’s IP address.
5.Click Next. This displays the Dynamic Host Configuration Protocol page.
Not Using PPPoE
If you selected Not Using PPPoE from the Untrusted Interface Configuration page, perform the following steps to specify how to obtain an IP address and subnet mask:
1.Select one of the following methods for obtaining an IP address:
•Obtain configuration automatically from Wan using DHCP to have an IP address assigned automatically using DHCP.
•Configure IP Routing manually to assign IP addresses manually. If you select this option, you must specify an IP Address, Subnet Mask, and Default Gateway in the appropriate fields.
2.Optionally select NAT Enabled. THis enables Network Address Translation (NAT), which allows multiple workstations on your LAN to share a single, public IP address. All outgoing traffic appears to originate from the router’s IP address.
3.Click Next. This displays the Dynamic Host Configuration Protocol page.
SIEMENS | 17 |
