Siemens SX763 LED, State, Status, First steps, Checking the operating state

First steps

Checking the operating state

Your Gigaset SX763 WLAN dsl is now ready for use. The LED displays on the front panel of the Gigaset SX763 WLAN dsl provide information about the operating state:

The LEDs (from left to right) have the following functions:

LED	State	Status
	On (green)	The Gigaset SX763 WLAN dsl is connected to the mains.
Power	Off	The Gigaset SX763 WLAN dsl is disconnected from the
		mains.
	On	A DSL connection is established.
	Flashing	The DSL line is being synchronised. The synchronisation
		phases are shown as slow flashing (registering) and fast
ADSL		flashing (training).
		If no DSL cable is connected, the LED will flash at uniform
		intervals.
	Off	DSL is deactivated.
	On	One of the connected phones' receivers has been lifted for a
		call (fixed network telephony).
Line
	Flashing	The phone is ringing and a fixed network call is being
		received or someone is waiting on the line.
	Off	There is currently no fixed network connection.
Online	On	Connection to the Internet has been established.
	Off	There is no Internet connection.
	On (green)	A device is connected to the Gigaset SX763 WLAN dsl via the
		USB port.
	Flashing	The connected device is active.
USB	(green)
	Flashing	The device connected on the USB port is using too much
	quickly	power (see (page 131)).
	Off	There is no device connected.
LAN1 –	On	A device is connected to the relevant LAN port.
	Flashing	The relevant LAN port is sending or receiving data (traffic).
LAN4
	Off	There is no device connected.
	On	The radio interface is active.
	Flashing	The Gigaset SX763 WLAN dsl is sending or receiving data on
WLAN		the radio interface.
	Off	The radio interface has been deactivated or no radio signal
		is being received.
	On	At least one port is configured for VoIP and VoIP access is
VoIP		registered with the provider.
	Flashing	A call is currently being made via the Internet.
	Off	There is currently no connection for Internet telephony.

29