Siemens V 4.0 manual Foreignsession, Address, Inconverter, Outconverter

Druck vom 24. 01.2001 17:00.44 torb-kon

Creating a configuration file using WinConfig

The following table describes the dialog window entries; the “Statement” column specifies the corresponding statement that is generated by WinConfig when saving to a configura- tion file.

Parameter name	Value	Default	Statement
Protocol	Name of the protocol used	LU6.1	FOREIGN_SESSION
Me -> Other	Number of connections controlled	1	SESSION-POINT
	by the Me application
Other -> Me	Number of connections controlled	1	SESSION-POINT
	by the Other application
AddressMe	Specifies how the other foreign or	none	ADDRESS
	TA application is to be addressed
	(see section 6.2 on page 46).
	The two parameter values must be
	separated by a dot.
AddressOther	Specifies how the other foreign or	none	ADDRESS
	TA application is to be addressed
	(see section 6.2 on page 46).
	The two parameter values must be
	separated by a dot.
In_Converter	Function ID of the converter func-	none	IN_CONVERTER
	tion or Class ID and ClassMethod
	ID of the converter class method
	(see section 6.2 on page 46 ).
	When entering a Class ID and a
	ClassMethod ID, they must be sep-
	arated by a dot.
Out_Converter	Converter ID of the converter func-	0	OUT_CONVERTER
	tion (see section 6.2 on page 46).
	If you enter 0, WinConfig does not
	create an OUT_CONVERTER state-
	ment.
Map_System	Enable/disable mapping	no	FOREIGN_SESSION
	(see section FOREIGN_SESSION
	on page 54)
	Possible values: yes / no
	Selected via a toggle button

GINA V4.0 System Administrator Guide – September 2000 119