MP215 Mobile Modem | Installation, Configuration, and User’s Guide |
Legend:
∙Command
∙WS181
∙Notes, Exception
AT Commands
The AT command
The required state of WS181 register (defines the operational mode). If blank, it means don’t care or not applicable. Otherwise an ERROR response will result if WS181 is not in the specified state.
Special notes, including how the command executes. “Not supported” means the command will return an ERROR response.
Command | WS181 | Notes, Exceptions |
A |
| Not supported |
D |
| Enters SLIP state. Dial numbers and |
|
| modifiers ignored. Enables |
|
| |
Fn |
| Not supported |
Hn |
| Value ignored. |
In |
| I5 reports Processor Board firmware |
|
| string |
|
| I7 reports “C” |
|
| I8 reports MP210 ATI5 response |
On |
| Exactly same as command ATD |
Zn | 0 | Reloads current Novram defaults for this |
|
| mode. |
Zn | 1 | Reloads current Novram defaults for this |
|
| mode. |
Zn | 3 | Reloads current Novram defaults for current |
|
| mode as per 0,1 above. |
&Cn |
| Not supported. &C1 is implicit default |
&Dn |
| &D1 not supported. &D0 and &D2 |
|
| supported as expected. |
&Fn | 0 | Reloads factory defaults <n> for this mode |
&Fn | 1 | Reloads factory defaults <n> for this mode |
&Fn | 3 | Not supported |
&In |
| Not supported |
&Kn |
| Not supported. &K3 is implicit default. |
&Rn |
| Not supported |
&Sn |
| Not supported |
&W | 0 | Saves current settings for this mode. |
&W | 1 | Saves current settings for this mode. |
&W | 3 | Not supported. |
PN 2110036 Revision 1.0 | 05/11/99 |
