Silex technology SX-500-1402 manual Command Description, Tls Psk, SET NW Ethauth Ttls TLS Peap

Command

Description

SET NW	Sets wireless authentication type
AUTHtype	The default value is Open System
	Format:
	SET NW AUTHtype [OPEN SHARED TTLS LEAP PEAP
	TLS PSK ]
	NOTE: For FIPS 140-2 approved operation, this parameter
	must be TLS, PEAP or PSK
SH NW AUTH	Shows wireless authentication type
	Sample output:
	Authentication type= OPEN SYSTEM
SET NW	Sets Ethernet wired authentication type
ETHAUTH	The default value is Open System
	Format:
	SET NW ETHAUTH [TTLS TLS PEAP ]
SH NW ETHAUTH	Shows Ethernet wired authentication type
	Sample output:
	Authentication type= PEAP
SET NW	Sets number of times the Serial Device Server will attempt to authentication
AUTHTRY	The default value is 0.
	Format:
	SET NW AUTHTRY n
SH NW AUTHTRY	Shows number of authentication tries.
	Sample output:
	Authentication Try Count = 3
SET NW CHannel	Sets WLAN ad-hoc channel number
	The valid numbers are 1 through 11.
	Format:
	SET NW CHannel n
SET NW ENC	Sets WLAN Encryption Mode.
	Supported modes are None, 64 bit WEP, 128 bit WEP, WPA, WPA2, WPA2-WPA
	The default value is Disable.
	Format:
	SET NW ENC [Disable 64 128 WPA WPA2 ]
	NOTE: For FIPS 140-2 approved operation, this parameter
	must be WPA2.
SH NW ENC	Shows the wireless encryption mode
	The deprecated command SH NW WEP also displays this information.
	Sample output:
Console Commands	Silex	Page 41
	Part Number 140-00188-210A