![](/images/new-backgrounds/1192624/19262471x1.webp)
Parameter
Command
Description
Echo control | ATEn | If n=0, commands are not echoed. |
|
| If n=1, subsequent commands will be echoed. |
|
| The default, upon unit reset, is for no echo (ATE0). |
|
|
|
Disconnect | ATHn | If n=0, any connection to a remote host is dropped. |
|
| Other value of n is ignored. |
Return to data mode | ATOn | Exits command mode and places the serial port in the |
|
| data mode. |
|
| All subsequent data is sent to the network application, if |
|
| connected, until an enter command mode sequence is |
|
| received. Any value of n is ignored, if present. |
Quiet mode | ATQn | If n = 1, no result codes are returned. |
|
| If n = 0, result codes are returned to the local device. |
|
| 0 is the reset default value. |
Verbose mode | ATVn | If n = 0 and not in quiet mode, result codes are |
|
| returned in numerical form. |
|
| If n = 1, results are returned as text. 1 is the reset |
|
| default value. |
Table 6 Extended AT Commands
Parameter
Command
Description
Console pass through | AT#C<string> | Passes the string to the server configuration console. |
|
| The string can be any valid console command. Refer |
|
| to your server documentation for console commands |
|
| available on your unit. |
|
| Since this command does not follow the normal AT |
|
| command format of <command><number>, it must |
|
| be the last command on the line unless the next |
|
| command is a '#' command. All characters up to the |
|
| end of line or a '# will be considered part of the |
|
| console command. |
|
| If console quiet mode is not is enabled, then the |
|
| response will be the standard console task response. |
|
| Example: |
|
| AT#Cset nw ssid silex#Csave |
Console Quiet mode | AT#Qn | If n = 0, a response to a #C command is given. |
|
| If n = 1, the response is not provided. The default |
|
| after reset is 1. |
Page 30 | Silex | Advanced Configuration |
| Part Number |
|