Installation

To connect the device to two speakers use only the cables for the front speakers.

NOTICE

GB

Make sure that a permanent positive connection is applied to the station memory of connection 4 in the ISO block A.

In some automobile models the standard configuration of the connections [4] and [7] in ISO block A are interchanged at the factory. If this is the case the station memory can be lost. To correct this, the connections 7 (Ignition positive) and 4 (Permanent positive) in the ISO Block A must be swapped.

You can connect an external amplifier to the audio cinch output. For this follow the operating instructions for the external amplifier.

Antenna power connection

IMPORTANT

Possible damage to the device!

Never attach the antenna power connection with the antenna's motor power cable.

The connection for the antenna power is available for a relay controlled antenna. The relay then automatically extends the antenna when the device is switched on. When switched off the antenna retracts. This connection can also be used to control an external amplifier. For exact connection information please consult the amplifier's operating instructions.

Connection of an external amplifier

For the connection of an external amplifier use the audio cinch output LINE OUT 39 . For this follow the operating instructions for the external amplifier.

Connecting the microphone unit

For connection of the microphone unit use the microphone unit socket 37.

Bluetooth Car Radio KH 2376

15

Page 13
Image 13
Silvercrest KH 2376 Antenna power connection, Connection of an external amplifier, Connecting the microphone unit