Sim2 Multimedia HT305 installation manual Connections, State Indicators Green RED

Switching off and returning to stand-by

By remote control: press

By keyboard: press key

When switching off, the projector goes in to stand-by memo- rising the input selection at the time of switch-off.

The fans will continue to work until the lamp has cooled down

(red and green LEDs flashing) and will stop automatically after this period.

Led indicators

The LED indicators, located in the top-rear of the projector, provide information about the state of the projector (see table below).

STATE	INDICATORS		NOTES
	GREEN	RED
POWER OFF	OFF	OFF	The Power is turned off
INITIALIZATION	ON	ON	Power button has been pressed and the software is initialized (15 s)
STANDBY	OFF	ON	Projector is in standby mode
OPERATING	ON	OFF	Projector is on
COOLING LAMP	FLASHING	FLASHING	Projector is powering down; the fans are running to cool the lamp (1 min)
WARNING	FLASHING	OFF	Problems to display one or more source
ERROR	OFF	FLASHING	Internal circuit failure

6 CONNECTIONS

To obtain the best performance from your projector, we recom- mend the use of good quality “video cables” to the various signal sources (75 ohm Impedance).

Poor quality cables will cause inferior picture performance.

For optimum connectivity we recommend you follow these simple steps:

ZOOM

2 1

		RGB
4	GRAPHICS
	(RS	232)
CONTROL

		AT						fusib		against
		la protectionpar un
		remplacer				caracteristiqueprotection
		et	de mems
					for continued
		CAUTION:replace
R/Cr		risk of		fire,			type
					same
		only with			fuse.
		and rating							AUDIO
G/Y	3		5	HDMI					OUT
B/Cb
	HV

75

-With exception of coaxial RCA/Phono type connectors, always double-check that the plug is inserted the correct way round to avoid damaging the plugs or the sockets on the projector (Fig. 16)

Fig. 16

-Remove cables by the plug and do not pull on the cable itself.

-Avoid tangled cables.

-Position the cables carefully to avoid a trip hazard - especially in low light areas.

12