11 TROUBLESHOOTING GUIDE
No power (Green and red LED are OFF)
-Check the power switch at the rear: it must be in position I.
-Check if the power cable has been connected correctly to a working socket.
-Check the power socket fuse, at the rear of the projector.
-Replace the fuse on the mains socket with an identical type (T 3.15A H) (Fig. 2).
-Should the problem persist, seek authorised technical assi- stance.
The lamp is not coming on
-Allow a few minutes pause between switching off and turning on again (from
-If the lamp doesn’t come on – even though the projector has had sufficient time to cool down – seek technical assistance from your nearest Dealer.
No image
-Check that the selected input is actually connected to a active video or graphic signal.
-Check that the above source actually works.
-Verify compatibility of video/graphic signals with the technical specifications of the projector.
-Check the integrity of cables used to connect various sour- ces.
-Check temperature of the room: it must be below 35°C (95°F)
-Check projector air vents on top and underneath the projector: they must be free of obstruction.
-If the problem persists, consult your Dealer.
Image is disturbed, unstable or noisy
-Verify compatibility of video/graphic signals with the technical specifications of the projector.
-Check the integrity of cables connecting projector to various sources.
-If the signal source is a terrestrial broadcast (via a VCR) check that the receiving channel has been correctly tuned in and
that the aerial system is in good working order.
-Should the problem be present with a signal coming from a
-Adjust the VCR’s tracking control for optimum picture per- formance. Ensure the VCR mode is active in the Picture menu.
Incomplete image along borders (vertical and horizontal)
- Compare compatibility of video/graphic signals and techni- cal specifications of your projector.
-Press Auto (on your remote or keypad) to execute automatic adjustments.
-Adjust the horizontal and vertical position of projected image by selecting Position on the Image Adjustments menu.
-Adjust the width and height of image, selecting Aspect in the Image Adjustments menu.
Image too dark, too pale or unnaturally coloured
-Verify compatibility of video/graphic signals with technical specifications of your projector.
-Go to Picture menu, select and regulate any of the following, accordingly: Contrast, Brightness, Color, and Tint.
-If necessary, reset the Color Temperature and Gamma Correction (found on the Image Adjustments / Advanced Settings menu).
Graphic image with poor quality vertical detail
-Verify compatibility of video/graphic signals with technical specifications of your projector.
-Press Auto (on your remote or keypad) to execute automa- tic adjustments.
-Adjust Frequency and Phase parameters, found in the Image Adjustments menu, to optimise vertical detail of the projected image.
27
