SAVE DEFAULT SETTINGS
To restore the original values to a previously modified Memory, select the line corresponding to the Memory in question and open the
RENAME A MEMORY
It is possible to assign a name to each Memory. To assign a name (with a maximum length of 12 alphanumeric characters) to a Memory, select the option ‘Rename’ from the correspond- ing
RESTORE CURRENT SETTINGS
On entering the ‘Memories’ menu, a copy of the current set- tings is saved in a temporary menu (labelled with 0 - AUTO). Once one or more memories have been recalled, you can re- store the settings that were effective at the moment the Memo- ries menu was accessed by selecting 0 - AUTO. However, this operation must be completed before the ‘Memories’ menu page disappears (30 seconds after the last operation commanded from the remote control or the keypad). The next time it ap- pears, the temporary memory will contain new information that takes into account any Memories selected the penultimate time the ‘Memories’ page was accessed.
Memory 0 (- AUTO) can be used even when you do not wish to enable the Memories management function for the signal currently in use. Once Memory 0 has been selected, when a source is chosen, the settings that were effective at the time the Memory was previously recalled will be automatically applied.
INFO
Displays the current status of the Display and information concerning the projected video/graphic signal.
This function is displayed on pressing 
on the remote control (or, in the absence of the On Screen Display, the key on the remote control).
QUICK MENU
The quick menus provide access to the main adjustments that affect image quality, without calling the main On Screen menus. BRIGHTNESS, CONTRAST, COLOUR, TINT, SHARPNESS and FILTER adjustments appear at the bottom of the screen one after the other when the and keys are pressed .
MESSAGES
The following messages may appear during operation of the system:
No signal
The system does not recognise any signal applied to the selected input. In this case:
•Make sure the selected input is connected to a video or graphic signal and that that source is functioning correctly.
•Check the condition of the cables used to connect the system to the various sources.
•Make sure the video or graphic signals supplied by the source are compatible with the system’s technical specifications and, in particular, with those of the selected input.
Out of Range
This message appears when either the resolution or the vertical/ horizontal frequency of the input signal exceeds system specifications (e.g. a QXGA graphic signal) or when an input is supplied with an incompatible signal (after setting the components input to YCrCb 15kHz a progressive signal is connected).
20
