2 IMPORTANT SAFETY INSTRUCTIONS
ATTENTION:
To reduce the risk of electric shock, disconnect the power supply cable on the rear panel before removing the top cover of the Display.
Refer to trained, authorised personnel for technical assistance.
CAUTION | ! |
RISK OF ELECTRIC SHOCK! | |
DO NOT REMOVE THE TOP COVER | |
|
This symbol indicates the possible electric shock hazard associated with uninsulated live components in the interior of the unit.
This symbol indicates the presence of important instructions regarding use and maintenance of the product.
The RTX system consists of two parts connected by a fibre optic cable: the DigiOptic™ Image Processor and the Display. In this manual references to the “unit” refer to one of the two units that make up the system.
Prior to switching on the Display please read each chapter of this manual carefully as this manual provides basic instructions for using the Display.
The installation of the lamp assembly, preliminary adjustments and procedures that necessitate the removal of the top cover, must be carried out by authorised, trained technicians. There are no user serviceable parts inside. To ensure safe and long term reliability please use power cables supplied with the Display. Observe all warnings and cautions.
CLASS 1 LASER PRODUCT
This product complies with fda radiation performance standards, 21 cfr chapter 1 subchapter j.
This product complies with european standard en 60825.
This product is classified as a class 1 laser product and there is no hazardous radiation with the safety protection.
Danger! Invisible laser radiation when open. avoid direct exposure to beam. Do not open the covers of the product and never touch the internal parts in order to avoid exposure to visible or invisible laser radiation.
• Federal Communication Commission (FCC Statement)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is used in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determinated by turning the equipment off and on, the user is encuraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/Tv technician for help.
• For customers in Canada
This Class B digital apparatus complies with Canadian
•For customers in the United Kingdom ATTENTION: This apparatus must be earthed
The wires in this mains lead are coloured in accordance with the following code:
Blue:Neutral
Brown:Live
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:
The wire which is coloured
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
3
