Simplicity OSHK80, HMSK110, HMSK80 manual Auger and Impeller Group, 985466

Auger and Impeller Group - 24”

NOTE: Unless noted otherwise,		985466
use the standard hardware torque
specification chart.
	End of hub to be flush
	with end of rolled down
4	shaft (Ref. 9).	1

Torque to 30 -34 ft-lbs.

40 - 46 Nm.

2

14 16

17

18

11

10

10

		5
10	7	6

9 8

2

	Torque to
3	18-21 ft-lbs.
	24 - 28 Nm.

15

19

6

12

13

Impeller to be positioned against bearing before tightening set screw.

Marked side of worm gear must contact against left thrust washer to assure proper gear mesh.

20 21 22

18 23

14

29	26	25
		24

Torque to 9 - 11 ft-lbs.

12- 15 Nm.

27

Auger assembly stamped "R".

Apply grease until

28it appears at ends of auger assembly (2 places).

Auger assembly stamped "L".

The above parts group applies to the following Mfg. Nos.:

1693650	860M, 8HP Manual Start	1693985	860M, 8HP Manual Start (Export)
1693651	860M, 8HP Manual Start (Export)	1694242	860E, 8HP Electric Start
1693763	860M, 8HP Manual Start	1693652	860DLX, 8HP Manual Start
1693775	860M, 8HP Manual Start (Export)	1693653	860DLX, 8HP Manual Start (Export)
1693984	860M, 8HP Manual Start	1694241	860DLXE, 8HP Electric Start

© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved. 44 TP 400-2307-03-LW-S