SECTION 2 – OPERATING INSTRUCTIONS
2.2CONTROLS – FUNCTION AND OPERATION
(Continued from previous page)
2.2.9.Headlights. The headlights are controlled by a rocker switch, located on the dash to the immediate left of the steering wheel. See Figure 2.5. Push the switch up to turn the headlights on. Push the switch down to turn the headlights off. Note: The engine ignition switch must be in the “RUN” position for the headlights to operate. Repair
2.2.11. Speedometer/Fuel Gauge Combo. | Both |
functions are contained within the one dial. See Figure | |
2.6. Speedometer measures ground speed of unit. | |
Fuel gauge indicates amount of fuel in tank. |
|
2.2.12. Hourmeter/Tachometer/ServiceMinder |
|
Combo. See Figure 2.6. With ignition off, LCD | |
readout displays hours engine used. With engine | |
started, readout displays RPM’s. After first seven (7) | |
hours of use, and every | |
the ServiceMinder displays a message indicating oil | |
change is required. The message will be displayed for | |
two (2) hours, and will continue even if oil is changed | |
within the two hour period. After two hours, whether oil | |
CABLE IN
CABLE OUT
WINCH
SWITCH (NOT ALL MODELS)
ON
OFF
HEADLIGHT SWITCH
is changed or not, display will revert back to |
hourmeter/tachometer function. |
2.2.13. Cargo Bed. The manual lift * cargo bed is |
secured in the lowered position by two spring latches |
located on either side of the machine. Pull outward on |
the latch lever (located behind the left cargo bed lift |
handle) to release the bed, and lift via the handle. Use |
the prop rod to secure the bed in the fully raised |
position. (NOTE: make sure slot in bottom of prop rod |
fully drops onto catch bolt in machine frame; failure to |
do so can result in serious injury.) The tailgate can be |
opened by flipping open the two tailgate latches located |
FIGURE 2.5
2.2.10.Ignition Switch. The ignition switch has three positions – Stop, Run, and Start. See Figure 2.6. Turn key and hold momentarily at “Start” position to crank the engine. After starting, release key to “Run” position. Turn key to “Stop” position to stop engine. Turning the key to the “Run” position will enable use of the headlights and the 12 volt accessory plug. However, when using the headlights or accessory plug, the engine should be running to prevent discharging the battery.
on either side of the tailgate and dropping gate down. |
* An electrically operated bed lift kit is available. |
Contact dealer for details. |
2.2.14. Powerlink™ Generator System (not on all |
models). See Pages |
generator. |
2.2.15. Warn™ Electric Winch (not on all models). |
The winch switch is located on the dashboard next to |
the headlight switch, to the left of the steering wheel. |
Pushing the switch down lets cable out; pushing the |
switch up pulls cable in. See Figure 2.5. Refer to |
manuals supplied with literature package for |
RUN
STOP |
| START |
|
|
|
HOURMETER /
TACHOMETER /
SERVICEMINDER
DISPLAY
IGNITION SWITCH
SPEEDOMETER
FUEL GAUGE
comprehensive instructions on safe use and |
maintenance of electric winch. |
WARNING
The winch switch on the utility vehicle does not automatically cut out when cable is fully retracted. To avoid damage to winch and/or vehicle, inspect cable regularly while retracting.
FIGURE 2.6
16
